Anntlent AN-L70V-01 Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przedłużacz Anntlent AN-L70V-01. Anntlent AN-L70V-01 10 stron. Cell phone signal booster

Introduction

With the popularity of mobile communications, people want to make a call anytime, anywhere,

so the coverage requirement of communication network is higher and higher, but the reality is

not so, sometimes mobile phone signal is not very good, you want to make a smooth call, even in

some places cell phone cannot dial out. in this cases, cell phone signal booster can solve this

problem in a certain extent.

Features

■ AGC(Automatic Gain Control): When the downlink output signal is too strong or self- oscillated,

the uplink and downlink can automatically reduce the gain and reduce the interference signal

■ Self- Oscillation elimination: The system detects self- Oscillation, first reduces the link

gain, then detects the loop, and finds that the self- oscillation is eliminated, the system returns

to normal working state, otherwise, the power is turned off to prevent interference signal.

■ Inactivity Mode: When no user calls, the device is in standby mode, the uplink power amplifier

is switched off, and the static power is decreased by 30%, so as to achieve the purpose of energy

saving.

SAFETY WARNINGS

WARNING:

This equipment should be installed and operated with minimum

distance 20cm （8 inches）between the radiator& your body.

FCC Cautions:



Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC rules. Operation is subject to the



following two conditions: (1) this device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.



This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. End users must follow the specific operating instruction for

satisfying RF exposure compliance.



This transmitter must not be co-located or operating in conjunction with any other

Antenna or transmitter.

This equipment has been tested and found to comply with the limits for a Class B



digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the

2 / 10