DS SG6000 Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przenośny generator DS SG6000. DS SG6000 4 stron. Rf signal generator

•

Download and open the DS Instruments Signal Generator Control GUI from the website. Install any .NET

framework updates from Microsoft if needed.

•

Select a COM port from the top select list and press CONNECT to try to control the unit. If the select box turns

green then a connection has been established. The model number and firmware versions will appear in the

green info box. If this box is turns red, the wrong COM port was selected or an error has occurred.

•

At this point a user can enter a frequency and click APPLY or setup a frequency sweep.

•

The blue RFO led on the front of the SG unit indicates that it is successfully locked and outputting the desired

frequency on the output port

•

The physical control buttons will be disabled when a COM port connection is established to prevent any

accidental bumping of the buttons when under computer control.

Control Software Feature Descriptions

1. COM / Ethernet search and connect – Lists any COM ports or DSI IP addresses found

2. Info Box – Displays information about the connected device

3. Custom Name – Lets the user save a TAG ID, Name, or inventory number to non-volatile memory

4. Reference frequency source – Sets internal, external or auto detect for the 10MHz reference input

5. Custom Command – Type or select a custom SCPI serial command to send to the connected device

6. Frequency – Step or enter a frequency to generate

7. RF Output Power – Adjust the output power in calibrated 0.5dB steps

8. RF Enabled – Set the RF output port to ON or OFF

9. Sweep Settings – Set the bounds, number of points, direction, and type of frequency sweep

10. Sweep Control – Save the current sweep settings to the device, start or abort the sweep

Version 4.0 – DS Instruments 2022 – www.dsinstruments.com