3M Dynapro ET 3170 Terminal Series B Instrukcja instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Monitor 3M Dynapro ET 3170 Terminal Series B. 3M Dynapro ET 3170 Terminal Series B 6 stron. Desktop stand's installation: terminal and computers
Również dla 3M Dynapro ET 3170 Terminal Series B: Instrukcja instalacji (4 strony), Instrukcja instalacji (3 strony), Instrukcja instalacji (4 strony), Instrukcja instalacji (2 strony)
Drukuj stronę
Equipment
Materials supplied
The following materials are supplied for installing the
NEMA 4X hatch:
1 NEMA 4X hatch (with removable plate attached).
!
1 NEMA 4X extended hatch cover
!
1 gasket
!
4 #6-32 Phillips screws
!
Cable fitting components (3 large sizes and 3 small
!
sizes of each component are provided):
Locking nut
!
O-ring
!
Body hex with compression sleeve
!
Sealing nut
!
3M Touch Systems Proprietary Information
2
For details about the supplied cable fitting
components, see Table A.
Tools required
To install the NEMA 4X hatch, you will need the
following:
Horizontal work surface with a padded cover or foam
!
pads to protect the front bezel and the display of the
unit.
Flat blade screwdriver with 3/16-inch blade
!
No. 1 Phillips torque screwdriver
!
1 19/32" (15 mm) open-end wrench
!
1 15/16" (24 mm) open-end wrench
!
Attaching the gasket
Important
If you ordered the ET 350L3 monitor, the hatch gasket was
attached at the factory. Proceed to "Preparing the hatch for
cables".
1. Place the ET unit face down on a horizontal work
surface (covered with foam pads or other material to
protect the unit's bezel and touch screen), with the
access hatch facing you.
2. Before removing the gasket backing, position the
gasket over the recessed edge of the access hatch
opening so that you know which way it fits.
Installing the NEMA 4X Hatch