Daintree GE Lumination LSA T1 Instrukcja instalacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria Daintree GE Lumination LSA T1. Daintree GE Lumination LSA T1 8 stron.
Drukuj stronęOPTION C - SENSOR ACCESSORY INSTALLATION STANDALONE UNIT
(NO LED FIXTURE).
FOLLOW OPTION A OR B FOR NON ENCLOSED OR ENCLOSED INSTALLATION
1
DISCONNECT POWER
Remove power by switching circuit breaker to the
off position.
MAKE ELECTRICAL
3
CONNECTIONS
120-277VAC
LINE
DC+
NEUT
DC-
Connect wires from the power supply or LCA Kit to the
sensor input wires. Connect the power supply input wires
to the appropriate power source. Use only U.L. approved
wire connectors for all electrical connections. Be sure to
insulate unused leads INDIVIDUALLY to 600Vrms using U.L.
approved wire connectors.
TM MULTI-SENSOR
5
ORIENTATION MARK
For the WMZ10 TM Multi-Sensor there is an arrow on the
lens. This arrow is a mark or indicator for the direction of
the sensor.
DC+ (RED)
DC- (BLACK)
2
VERIFY POWER SUPPLY AND
SENSOR ARE COMPATIBLE
+
COMPATIBLE
POWER SUPPLY
(WMZ10 only)
OR LCA KIT
To verify a compatible power supply, please refer to
the Power Supply Compatibility List table on the Multi-
Sensor (TM) spec sheet. Note: Connect TM sensor to GE
Lighting Solutions LLC LED drivers or control modules
not capable of providing greater than 15VA power,
including but not limited to models listed in Power
Supply Compatibility List.
CEILING INSTALLATION (SEE
4
OPTION A OR B)
OPTION A
• Direct ceiling install
(CMP cable used)
Install the sensor unit into the ceiling following the
same steps as mentioned in Option A or B of this
installation guide.
TM MULTI-SENSOR
6
ORIENTATION REQUIREMENT
When the sensor is installed, all sensors should face the
same direction. The arrow can be used to point all sensors
in one direction. As a reference all sensors installed should
have the arrow pointing North.
N
W
E
S
=
OPTION B
• Metal box/conduit
install
5