Daintree WWD2-4SM Instrukcja instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Systemy kontroli Daintree WWD2-4SM. Daintree WWD2-4SM 7 stron. Wireless controls wireless scene switch
Również dla Daintree WWD2-4SM: Instrukcja instalacji (7 strony)
Drukuj stronęInstallation
1
Use a standard screwdriver
to open the faceplate. Pull
the plastic insulation strip
out of the battery
compartment.
4
want to install the device on
the wall, use the 3M tape in
the package to stick the
device firmly on the wall.
Network Reset
2
want to install on the
junction box, use the screw
in the package and a cross
screwdriver to lock the
device on the junction box
5
If you
You can also use the device
handheld in the signal coverage
area of the commissioned system.
To reset the network of the device,
remove the faceplate from the device.
Then press and hold the reset button for
5 seconds. Install the faceplate back onto
the device. Press either dimming up or
down button to enter the pairing mode
to join the device to a network.
currentlighting.com
© 2022 HLI Solutions, Inc. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
LightOWL® Dual Technology Passive Infrared
and Acoustic Sensors (LODIA)
INSTALLATION INSTRUCTIONS
3
Install the faceplate onto
If you
the device. Note: Device
supports the use of other
standard faceplates on the
market.
WWD2-4SM
Installation Guide
Page 2 of 7
Rev 03/14/23
DT_WWD2-4SM_InstallSheet