Daisy BELOW GROUND Instrukcja instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt oświetleniowy Daisy BELOW GROUND. Daisy BELOW GROUND 4 stron. Pool cover box
Drukuj stronęITEMS YOU WILL NEED TO INSTALL THE BOX
• 2 ropes or straps to carry and lift box
• Shovels
• Tape measure
• Spirit level or levelling device
• Rubber mallet
Electrical Bonding AS/NZS 3000:2018
(Wiring Rules):
If unit is installed within arm's reach
(1.25m) of the pool edge, engage a
licenced elitrian to equipotential bond
the unit.
Check state legislation before
commencing works
INSTRUCTIONS
1. Prepare dig zone by
removing pavers if
being installed into
pre paved area.
3. If space is restricted on one side place box at
least 100mm past the pool edge or as far as
possible if pool wall is on a boundary, please
ask us for advice on placement in restricted
space circumstances.
Below Ground Box
• 17mm socket or spanner
• 2 concrete slabs 450mm x 450mm or 300mm
x 600mm
• Blue metal or stone aggregate equivalent
(approx. 2 bags per 1m).
256
Below Ground Box Small Model
2. Dig trench to
minimum of 550mm
wide and 555mm
deep (BGB) or
400mm wide and
410mm deep (BGB
Small) and at least
300mm past either
side of the pools
waterline edge. For
example if pool is
4000mm wide dig
trench 4600mm long.
4. Once trench dug
to correct size
and depth, place
concrete slabs at
each end where
angle braces are
located on the box
(approx. 1000mm –
1200mm from end
of box).
220