DSC PC1555MX Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System bezpieczeństwa DSC PC1555MX. DSC PC1555MX 11 stron. Power632

Drukuj stronę

System Information

Fill out the following information for future reference and store this manual in a safe place.

Access Codes

Your Master Code is: __________________________________________

Additional Access Codes:

01 __________________

09 ____________________

02 __________________

10 ____________________

03 __________________

11 ____________________

04 __________________

12 ____________________

05 __________________

13 ____________________

06 __________________

14 ____________________

07 __________________

15 ____________________

08 __________________

16 ____________________

Zone Information

There are ________ active zones on the system.

Zone

Protected Area

___________________________________________

17 ____________________

25 ________________

18 ____________________

26 ________________

19 ____________________

27 ________________

20 ____________________

28 ________________

21 ____________________

29 ________________

22 ____________________

30 ________________

23 ____________________

31 ________________

24 ____________________

32 ________________

Zone Type

_____________________________________

Fire Escape Planning

There is often very little time between the detection of a fire and the time it becomes deadly. It is thus

very important that a family escape plan be developed and rehearsed.

1. Every family member should participate in developing the escape plan.

2. Study the possible escape routes from each location within the house. Since many fires occur at

night, special attention should be given to the escape routes from sleeping quarters.

3. Escape from a bedroom must be possible without opening the interior door.

Consider the following when making your escape plans:

• Make sure that all perimeter doors and windows are easily opened. Ensure that they are not

painted shut, and that their locking mechanisms operate smoothly.

• If opening or using the exit is too difficult for children, the elderly or handicapped, plans for rescue

should be developed. This includes making sure that those who are to perform the rescue can

promptly hear the fire warning signal.

• If the exit is above the ground level, an approved fire ladder or rope should be provided as well as

training in its use.

• Exits on the ground level should be kept clear. Be sure to remove snow from exterior patio doors in

winter; outdoor furniture or equipment should not block exits.

• Each person should know of a predetermined assembly point where everyone could be accounted

for i.e.: across the street or at a neighbour's house. Once everyone is out of the building, call the

Fire Department.

• A good plan emphasizes quick escape. Do not investigate or attempt to fight the fire, and do not

gather belongings or pets as this wastes valuable time. Once outside, do not re-enter the house.

Wait for the fire department.

• Write the fire escape plan down and rehearse it frequently so that should an emergency arise,

everyone will know what to do. Revise the plan as conditions change, such as the number of

people in the home, or if there are changes to the building's construction.

• Make sure your fire warning system is operational by conducting weekly tests (see "Testing Your

System" on page 13). If you are unsure about system operation, contact your installing dealer.

• We recommend that you contact your local fire department and request further information on fire

safety and escape planning. If available, have your local fire prevention officer conduct an in-

house fire safety inspection.

Maintenance

With normal use, the system requires minimum maintenance. The following points should be observed.

1. Do not wash the security station with a wet cloth. Light dusting with a slightly moistened cloth should

remove normal accumulations of dust.

2. The battery/bell test is designed to determine battery condition. We recommended, however, that the

stand-by batteries be replaced every three years.

3. For other system devices such as smoke detectors, passive infrared, ultrasonic or microwave motion

detectors or glassbreak detectors, consult the respective manufacturer's literature for testing and

maintenance.