DSC PC51O2-433NA Instrukcja instalacji

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System bezpieczeństwa DSC PC51O2-433NA. DSC PC51O2-433NA 13 stron.

Drukuj stronę

PC51O2-433NA v1.0 Installation Manual

If you are intending to use DLS-3 software with this product, a new DLS-3 driver must be

downloaded from the DSC web site at http://www.dscsec.com/dls3drivers.htm. Install

this driver on your computer in the same directory as your DLS-3 software.

Section 1: Introduction

This manual describes how to install, program and maintain the PC5102-433. Before you

install the PC5102-433 module, you should complete the following steps in your system

installation:

1. Plan the installation and wiring of the security system (see your system Installation Manual ).

2. Install the control panel, and install and enroll at least one keypad to use for programming.

Program the PC5102-433 from a system keypad or using DLS-3 v1.3 with the PC5102-433

v1.0 Driver Pack. Read your system Installation Manual for more information.

1.1

How to Use this Manual

Read this manual before you begin installing the PC5102-433. To install and set up the

PC5102-433 and wireless keys, follow these steps. Refer to the sections listed below.

1. Temporarily mount and wire the PC5102-433 module (see Section 2 ).

2. Enroll and program wireless keys (see Section 3 ).

3. Complete PGM and other programming on the system (see Section 4 ).

4. Test the placement of all the wireless keys (see Section 5).

5. Permanently mount the PC5102-433 receiver (see Section 5).

For additional information on trouble conditions and battery replacement, see Section 6.

For help with troubleshooting, see Section 7.

1.2

Specifications and Features

• Current Draw: 50mA (standby) 200mA maximum (both outputs active)

• Frequency: 433 MHz

• Receiver can receive signals from up to 8 wireless keys

• Antenna - internal. Installation not required

• Location

- can be wired up to 750 ft/230m. from the main panel with 22 gauge wire

- connects to Keybus

- for longer wire runs, thicker gauge wire must be used

• Compatibility: The PC5102-433 v1.X can be connected to the following panels:

PC501X, P832/DL, PC5020, P-8+, PC1555, P-6B, PC1555MX, P-6BMX, PC580, P-48

1.3

Compatible Wireless Keys

Please refer to the instruction sheets of the following keys for more information.

The PC5102-433 v1.X can receive signals from the following keys:

• WLS909-433 Wireless Key

• PWLS909-433 Wireless Key

This manual contains information on limitations regarding

product use and function and information on the limitations as

W A R N I N G

to liability of the manufacturer.

firealarmresources.com

• WLS919-433 Wireless Key

• PWLS919-433 Wireless Key