DSC PC56O Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System bezpieczeństwa DSC PC56O. DSC PC56O 16 stron.

TESTING

Entering this command will sound the siren and turn ON all the keypad lights for 2 seconds. To perform a

∗

bell test, enter [

][4] on the keypad.

It is recommended that you test your system weekly.

NOTE: Perform system tests in the off-peak hours, such as early morning or late evening.

1 Call to inform your monitoring station that you are testing your system.

2 Disarm the system and ensure that the "Ready" light is ON.

3 Perform a Bell Test by entering [

on the keypad will come ON. If a trouble condition is indicated after the test, press [

trouble condition.

4 Activate each sensor on your system in turn. For example, open protected doors and windows, and

walk in areas protected by motion detectors. Each Zone Light should come ON when each zone is

activated. Each Zone Light will be shut OFF when the zone is restored to normal (when the door or

window is shut, or when motion stops in areas protected by motion detectors).

5 If they are programmed for operation, press the [F], [A], and [P] keys in turn. The [F] key will sound the

bell or siren in a pulsed mode. Enter an Access Code to silence the alarm. The [A] key is a silent

alarm; the [P] key may be programmed as silent or audible. If an alarm sounds, enter an Access Code

to silence the alarm.

6 Should the system fail to operate properly, call your alarm dealer for service.

7 When testing is complete, call and advise the monitoring station.

∗

][4]. The bell or siren will sound for 2 seconds and all of the lights

∗

][2] to view the