DAITEM SH146AX Instrukcja instalacji - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System bezpieczeństwa DAITEM SH146AX. DAITEM SH146AX 18 stron. External detector antimask

Drukuj stronę

Recommendations

The user must not attempt to access the

siren's internal parts, except areas described

in this manual. If the user does access these

parts, the product guarantee will be

considered null and void and DAITEM shall

not be held responsible for any problems.

Touching the siren's internal parts and/or

electronic components can damage the

product. Furthermore, the siren is designed

in such a way that these parts and

components do not need to be accessed for

operation or maintenance purposes.

9.1 Fault indications

The control panel responds to detector

battery faults, tamper faults and radio faults.

Battery fault:

Following a system command, the control

panel issues the voice message:

"Beep, fault, battery, detector X".

Tamper fault:

Following a system command, the control

panel issues the voice message:

"Beep, fault, tamper, detector X".

This fault is caused by the detector box not

being closed properly but may also be

triggered when the detector is completely

masked (the anti-mask function is triggered

when an opaque obstacle is placed in front

of the lens).

Radio fault

Following a system command, the control

panel issues the voice message:

"Beep, fault, radio, detector X".

IMPORTANT: briefly press on the test button

to check the detector's battery. The radio

card LED lights up red.

• The lithium battery pack must be replaced by the same type of pack with the same technical

characteristics, i.e. (3.6 V - 4 Ah).

• We advise you to use the DAITEM BatLi05 pack available in the catalogue in order

to guarantee individual safety and equipment reliability.

• Dispose of the waste lithium power pack in an appropriate recycling bin.

9.2 Changing the battery

IMPORTANT: the detector's parameters are

saved when the battery is changed.

1. Put the Control panel into the Installation

mode by requesting the User to enter the

following:

master code

then enter:

installer code

2. Open the detector box

(see § 2. Preparation).

3. Replace the ﬂat lithium battery and close

the detector.

4. Put the control panel back in user mode

by entering:

installer code

5. Perform the operating test again

(see § 8. Operating test).