DAITEM SJ608AX Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System bezpieczeństwa DAITEM SJ608AX. DAITEM SJ608AX 8 stron. 2 function remote keyfob with information feedback, bi-protocol 4 function remote keyfob with information feedback,8 function 4 key remote keyfob with information feedback

Drukuj stronę

3. Recognition programming with a TwinBand

This step enables radio recognition between devices:
• the keyfob is recognised by the control panel,
• the control panel is recognised by the keyfob (for managing control panel information feedback on the keyfob).
To perform recognition programming, place the cursor in the top position for keyfob SJ608AX.
The control panel must be in installation mode. If it is not, enter:
master code (factory: 0000)
Perform the following recognition programming sequence:
then
10 s max.
Press and hold "Off"
Press
then # on
*
(orange LED flashes)
the control panel
until the control panel
keypad.
responds
IMPORTANT: the keyfob can recognise two different alarm control panels and manage information feedback from both.
4. Parameter-setting (TwinBand
The keyfob's parameters can be set in order to personalise commands in relation to the user's needs.

4.1 Setting a command number

1. Choose the keyfob key to be personalised (ON, OFF, P1 or P2)
2. Choose a command n° (2 or 3 digits) from the table below depending on the command to be set.
3. Choose a top or bottom cursor position (only for SJ608AX).
Command description
Command n°
OFF
(coded access compulsory)
Panic Alarm
Armed
Silent alarm
Armed, Partial 1
Armed, Partial 2
Fire alarm
Armed, Presence mode
(stay)
Silent command
Stop indications*
Door Bell Chime
Audible signal Chime
No command
Pulse light
Light OFF
* Used to stop indications concerning a technical alarm, an alert or a tamper alarm without changing the system status.
Important: telephone transmissions are not interrupted.
IMPORTANT
• To use the "Alert" or "Silent alarm" command, press and hold the key for 2 seconds in order to validate radio transmission.
• A key cannot be set with a TwinBand
radio link is deleted).
then
installer code (factory: 1111)
"Bip, remote control unit X"
The control panel issues
a voice message to
confirm keyfob
recognition
®

radio)

Command description
21
Light ON
22
Light toggle switch
23
Light timer
24
Pulse relay 1
25
OFF relay 1
27
Armed relay 1
32
Toggle switch relay 1
33
Timer relay 1
36
Pulse relay 2
37
OFF relay 2
38
Armed relay 2
42
Toggle switch relay 2
44
Timer relay 2
50
Pulse relay 3
52
OFF relay 3
®
command n° if an Optwin
®

alarm control panel

The keyfob's LED lights up
green for 1.5 s to confirm
control panel recognition
Command n°
Command description
54
Armed relay 3
56
Toggle switch relay 3
58
Timer relay 3
60
Pulse relay 4
62
OFF relay 4
64
Armed relay 4
66
Toggle switch relay 4
68
Timer relay 4
70
Off relay control panel 1
72
On relay control panel 1
74
Off relay control panel 2
76
On relay control panel 2
78
System status
80
82
®
radio link has already been allocated (unless the Optwin
3
IMPORTANT: deleting control
panel recognition on a keyfob
can only be done once the
keyfob has been put back into
its factory configuration.
Command n°
84
86
88
90
92
94
96
98
112
114
122
124
129
®