DAITEM SH273AX Instrukcja instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Czujniki bezpieczeństwa DAITEM SH273AX. DAITEM SH273AX 13 stron. Contact detector
Również dla DAITEM SH273AX: Instrukcja instalacji (4 strony)
Drukuj stronę3. Programming
During recognition
programming, the product to be
programmed for use with the
control panel does not need to
be placed next to it. In fact, we
recommend you place the
product at a short distance from
the control panel (at least
2 meters away).
Programming enables contact
detectors to be recognised by the
control panel.
1. To programme contact
detectors the control panel
must be in installation mode.
If it is not, you will require the
user's master code, press:
master code
then press:
engineer installer code
2. Programme the device as follows:
"detector X"
then
10 s max.
Press
Press
#
then
and hold the
on the
"test" button
control panel
until the control
keypad
panel responds
IMPORTANT: the control panel indicates an error by emitting 3 short
beeps. When this happens programming should be carried out again.
59
"group ?"
"time delay?"
to
to
*
* according
to the type
of control panel
The control panel
Choose the type
waits for a group
of triggering:
to be chosen (from
0: immediate
1 to 8)*. Choose
1: delayed
the groups by
2: combined
pressing the
Use the control
corresponding
panel keypad
numeral on the
to select the type
control panel
keypad
GB
"beep, detector X,
group Y,
immediate
(or delayed
or combined)"
The control
panel gives a
voice message
to confirm
detector
programming