ansio VENUS Instrukcje i instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcje i instrukcja obsługi dla Grzałka ansio VENUS. ansio VENUS 9 stron. Ptc ceramic tower heater

NOTE

There may be traces of smoke or odour arising from the heating coil when the heater

is first operated. This is expected and will quickly fade away and will not re-occur. If

the smoke or bad odour persists, do not use the heater and contact us for assistance.

BEFORE USING THE HEATER

1. Check if the power cord is in good condition.

2. Ensure that the heater is connected to an appropriate power socket in accordance

with the local regulations.

3. Always place the heater on a flat surface. The tip over feature will turn the heater

off if the heater is placed on an uneven surface or if the heater is accidentally

knocked off.

OPERATING INSTRUCTIONS

1. Insert the plug into the power socket and turn the switch ON.

2. The power selection knob will by default be in the OFF position at the centre.

3. From the OFF position, turn the power selection knob clockwise to choose between

one of the following modes:

LO Power Mode:

The heater operates at 1200 W without oscillation.

HI Power Mode:

The heater operates at 2000 W without oscillation.

4. From the OFF position, turn the power selection

knob counter- clockwise to choose between one of

the following modes.

LO & OSC Mode

The heater operates at 1200 W with oscillation.

HI & OSC Mode

The heater operates at 2000 W with oscillation.

5. Turn the Temperature Control Knob to adjust the heating to the required level.

Note: The temperature control knob acts as a thermostat. In the event of

overheating, the heater will be turned OFF automatically.

ANSIO 1320 (M21v01)