DSC AMB-500 Instrukcje instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Czujniki bezpieczeństwa DSC AMB-500. DSC AMB-500 4 stron. Addressable pir detector

Mounting

To open the case, remove screw and gently twist the top cover counter-clockwise and

lift it up from the bottom cover. Use a small screwdriver to remove the appropriate

knockouts for wiring. Mount the bottom cover.

To close the case, use the locating line on the bottom cover to align the tab on the top

cover. Once the top cover is engaged, twist the top cover clockwise to lock it in place.

Use screw to attach top cover to the bottom cover.

NOTE: Since no adjustment is necessary for the circuit board, it is not recommended

that the installer remove the circuit board from the case.

Device Enrollment

The serial number located on the back of the device must be enrolled into the alarm

control panel via Installer's Programming ([✱] [8] [Installer's Code]). This procedure is

outlined for the PC4010/4020 in the control panel Installation Manual and for the

Power panels in the PC5100 Installation Manual.

WARNING: Connect only DSC Addressable Series devices to the addressable

loop connections. Connection of ANY other type of device will impair operation.

Any devices other than Addressable Series devices which require power to oper-

ate must be powered separately.

Walk Testing

Once the detector has been set up, walk test the entire area where coverage is

desired. Should the coverage be incomplete, readjust or relocate the detector to

obtain full coverage.

IMPORTANT NOTE: Upon installation, the unit should be thoroughly tested to

verify proper operation. The end user should be instructed on how to perform

walk tests, and should walk test the detector weekly.

Changing the Sensitivity

AMB-500 features Fast and Slow detection modes, which are set on jumperJ1.

Jumper J1 is set at the factory for the Fast detection mode. In a normal operating

environment, this setting provides the best detection.

In certain environments where rapid air movement, heaters and other variables

present problems, use Slow detection mode to stabilize the detection.

To change the setting from Fast to Slow, take the jumper off the header.

firealarmresources.com