Anslut 012676 Instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wentylator Anslut 012676. Anslut 012676 7 stron. Bathroom fan
Drukuj stronę
SAFETY INSTRUCTIONS
•
Disconnect the product from the mains before
connecting, maintenance and/or repair.
•
Installation, maintenance and/or repairs
should be carried out by an authorised
electrician and in accordance with these
instructions.
•
The product is intended to be connected to
230 V 1-phase installations that comply with
local regulations.
•
The product must be connected via a
permanently installed automatic fuse with a
minimum contact gap of 3 mm on all
terminals.
•
Check before installation that the impeller
and casing are undamaged.
•
There must be no foreign objects in the
casing that could damage the fan blades.
•
The product must only be used for its
intended purpose and in accordance with
these instructions. Do not make any
modifications to the product.
•
The product is not intended to be used by
persons (children or adults) with any form of
functional disorders, or by persons who do
not have sufficient experience or knowledge
on how to use it, unless they have received
instructions concerning the use of the
product from someone who is responsible
for their safety.
•
Keep children under supervision to make
sure they do not play with the product.
•
Take the necessary precautions to prevent
smoke, carbon monoxide and other
flammable products from penetrating into
the room through open flues or other fire
safety devices.
•
Make sure that the air supply is sufficient for
correct combustion and adequate chimney
draught, to prevent backward flow.
•
The transported medium must not contain
dust or other solid particles, sticky
substances or fibres.
•
Do not use the product in explosive
environments, e.g. in the vicinity of
flammable liquids, gas or dust, or in
environments that contain toxic or harmful
substances.
•
Do not block the openings on the product to
attempt to direct or adjust the air flow.
•
The product is intended for permanent
connection to the mains.
SYMBOLS
Read the instructions.
Safety class II.
Approved in accordance with
the relevant directives.
Recycle end-of-life product
in accordance with local
regulations.
ELECTRICAL SAFETY
New installations and extensions to existing
systems should always be carried out by
an authorised electrician. If you have the
necessary experience and knowledge
(otherwise contact an electrician), you can
replace power switches and wall sockets,
fit plugs, extension cords and light sockets.
Incorrect installation can result in fatal injury
and the risk of fire.
TECHNICAL DATA
Voltage
Output
Air flow
Speed
Noise level
Safety class
Protection rating
Operating temperature
Size
EN
230 V ~ 50 Hz
14 W
95 m
/h
3
2300 rpm
33 dB
II
IP24
+1 to 40°C
136 x 117 x 98 mm
7