Anslut 012903 Instrukcja obsługi - Strona 16
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wentylator Anslut 012903. Anslut 012903 19 stron.
Drukuj stronę
EN
SAFETY INSTRUCTIONS
•
Disconnect the product from the mains before
connecting, maintenance and/or repair.
•
Installation, maintenance and/or repairs
should be carried out by an authorised
electrician and in accordance with these
instructions.
•
The product is intended to be connected
to 230 V 1-phase installations that comply
with local regulations.
•
The product must be connected via a
permanently installed automatic fuse with
a minimum contact gap of 3 mm on all
terminals.
•
Check before installation that the impeller
and casing are undamaged.
•
There must be no foreign objects in the
casing that could damage the fan blades.
•
The product must only be used for its
intended purpose and in accordance with
these instructions. Do not make any
modifications to the product.
•
The product is not intended to be used by
persons (children or adults) with any form
of functional disorders, or by persons who
do not have sufficient experience or
knowledge on how to use it, unless they
have received instructions concerning the
use of the product from someone who is
responsible for their safety.
•
Keep children under supervision to make
sure they do not play with the product.
•
Take the necessary precautions to prevent
smoke, carbon monoxide and other
flammable products from penetrating into
the room through open flues or other fire
safety devices.
•
Make sure that the air supply is sufficient for
correct combustion and adequate chimney
draught, to prevent backward flow.
•
The transported medium must not
contain dust or other solid particles, sticky
substances or fibres.
•
Do not use the product in explosive
environments, e.g. in the vicinity of
16
flammable liquids, gas or dust, or in
environments that contain toxic or
harmful substances.
•
Do not block the openings on the product
to attempt to direct or adjust the air flow.
•
The product is intended for permanent
connection to the mains.
SYMBOLS
Read the instructions.
Safety class II.
Approved in accordance with
the relevant directives.
Recycle discarded product in
accordance with local
regulations.
ELECTRICAL SAFETY
New installations and extensions to existing
systems should always be carried out by
an authorised electrician. If you have the
necessary experience and knowledge
(otherwise contact an electrician), you can
replace power switches and wall sockets,
fit plugs, extension cords and light sockets.
Incorrect installation can result in fatal injury
and the risk of fire.
TECHNICAL DATA
Voltage
Output
Flow
Safety class
Protection rating
Speed
Noise level
230 V ~ 50 Hz
18 W
98 m
/h
3
II
IP24
2300 rpm
34 dB