Foxfury Lighting Solutions 200-4N56 Instrukcja obsługi produktu - Strona 13
Przeglądaj online lub pobierz pdf Instrukcja obsługi produktu dla Sprzęt oświetleniowy Foxfury Lighting Solutions 200-4N56. Foxfury Lighting Solutions 200-4N56 18 stron.
Drukuj stronę
REPLACING THE BATTERY PACK | 4 MINS
1.
Attach the new Battery Pack to the light by re-clipping it the Connector.
Then, place the new Battery Pack back inside the Nomad
2.
Place the black strap over the Battery Pack. Then, re-insert and tighten
the two (2) screws.
3.
Place the rear panel back onto the Nomad
properly fit in one direction). Re-insert and tighten the eight (8) screws
using a Phillips screwdriver.
NOTE: Remember to test the light's performance by activating the Power/
Mode Switch.
REMOVING THE SLIDING DIFFUSER LENS | 3 MINS
1
1
1.
Slide the Sliding Diffuser Lens back into the 'Area' setting. Locate and
remove the four (4) screws located on each side of it.
2
2.
Then, tilt the Sliding Diffuser Lens forward.
3
3.
Pull the Sliding Diffuser Lens out and free from the Light Head.
FOR RE-INSTALLATION: Repeat the steps above in reverse order.
. Align as needed (it will only
®
2
(APPROX)
.
®
(APPROX)
3
13