Foxfury Lighting Solutions NOMAD 360 Instrukcja obsługi produktu - Strona 17
Przeglądaj online lub pobierz pdf Instrukcja obsługi produktu dla Sprzęt oświetleniowy Foxfury Lighting Solutions NOMAD 360. Foxfury Lighting Solutions NOMAD 360 20 stron.
Również dla Foxfury Lighting Solutions NOMAD 360: Skrócona instrukcja obsługi (6 strony)
Drukuj stronę
MODULARIZED REPLACEMENTS
The Nomad
Light Head is can be replaced if another color temperature is
®
needed, or if the unit is damaged or requires service. Please contact FoxFury
Customer Service (see pg. 19) for more information.
NOTE: Replace Nomad
Replace Nomad
®
T56 Light Heads.
REPLACING THE LIGHT HEAD | 4 MINS
1
TIL T ADJUSTMENT
KNOB
CONNECTOR
CABLE
SCREW
3
1.
Tilt the Light Head forward for easier access to the Connector.
1
2.
Use a small screwdriver to press the spring-loaded Detent (two (2) total).
2
(They are located on each side of the Connector). Press the Detent on
one side while pulling on the Connector Cable with minimal pressure. Keep
pressure maintained while pressing the Detent on the opposite side. The
Detent Cover will come loose allowing the Connector to be removed.
3.
Remove the Tilt Adjustment Knob (by twisting it until it comes off) and
3
Hinge Screw (using a Phillips Head ( + ) screwdriver) (reference Step 4 on
pg. 10 for location). Use caution when removing the Hinge screw as the
Light Head will no longer be connected to the Tripo-Scope
FOR RE-INSTALLATION: Repeat steps 1–3 in reverse order. Note the
orientation of the Connector when re-installing.
Prime Heads only with other Nomad
®
T32 and T56 Light Heads only with other Nomad® T32 or
2
HINGE
(APPROX)
DETENTS (2)
Prime Heads.
®
CONNECTOR
.
®
17