Anslut 001947 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Oświetlenie zewnętrzne Anslut 001947. Anslut 001947 12 stron. Garden lights

Drukuj stronę
EN

SAFETY INSTRUCTIONS

•
Do not attempt to modify the light.
•
The mains voltage must be protected by a
residual current device.
•
Do not use the light if the power cord or
plug are damaged in any way. To ensure
safe use the power cord must only be
replaced or repaired by an authorised
service centre.
•
Do not attempt to repair the garden light
yourself if it has been damaged. Contact
an authorised service centre.
•
Never use the garden light if the cover for
the lamp is defective. Replace the cover as
soon as possible.
•
Switch off the power supply before
installation, dismantling, or any other
interventions.
•
Never use light sources with a higher
output than specified in the technical data.
•
Disconnect the power supply and allow
the light source to cool before replacing.
•
Only use the supplied transformer.
•
The light must not be connected directly
to the mains without the transformer.
•
No other lights must be connected to the
transformer, or this light.
•
The plug must be connected to a power
point indoors (e.g. in the home, garage or
a shed) to protect it from the elements.
•
Do not look directly at the light source.

TECHNICAL DATA

Rated voltage
Rated output
Type of light source
Protection rating
Socket
Cord length
10
230 V ~ 50 Hz
6 x 3 W
LED
IP44
G4
11.6 m
DESCRIPTION
1.
Lamp
2.
Socket
3.
Foot
4.
Ground spike
5.
Lamp cord
FIG. 1
6.
Cover
7.
Diffusor
8.
Fasteners
9.
Top ring
10. Bottom ring
FIG. 2
ASSEMBLY
Light
1.
Release the diffusor from the socket.
2.
Insert a 3 W LED light source in the socket.
3.
Replace the diffusor in the socket.
4.
Insert the lamp cord in the lamp foot.
5.
Fasten the socket on the lamp foot.
6.
Fasten the ground spike in the lamp foot.
Make sure the lamp cord comes through
the recess in the ground spike.
7.
Repeat the above steps with the other
lamps.
Connection
1.
Place the transformer near the power
point to be used.
2.
Lay out the connection cord. Make sure
to place it so that nobody can trip over
it, and where it cannot be damaged by a
lawn mower.
3.
Place the lamps in their intended
positions. Make sure that the ground spike