Daitsu RTD-100-UT Instrukcja serwisowa - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Pilot zdalnego sterowania Daitsu RTD-100-UT. Daitsu RTD-100-UT 11 stron. Wire remote control

Drukuj stronę
Daitsu RTD-100-UT Instrukcja serwisowa
Installation figure as following:
A: Turn a screwdriver at the concave on bottom panel of the wired controller to remove the
back cover.
B: When installing the wired controller cover, it is sure that there is a hole in the wall to
avoid the wired controller back cover being fixed directly to the wall which is not allowed for
the wire joint extrudes out of the back cover.
C: When installing the wired controller, adjust the bottom of the controller board to the back
cover which should be fixed first, then press the other end of the controller board.
Notes: The connecting wire should be a little longer as to take away the switch board and
controller easily for maintenance.