3M Unitek Ortholux Luminous Curing Ligh Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt medyczny 3M Unitek Ortholux Luminous Curing Ligh. 3M Unitek Ortholux Luminous Curing Ligh 16 stron. Fast curing cordless led light
Drukuj stronę
Insert the battery:
• Remove the protective cap from the battery
and keep with the unit packaging.
• Slowly insert the battery with the thread side
towards the metal housing into the handpiece
until it stops. Screw the battery clockwise by hand
until the seal is pressed firmly against the metal
housing. The unit will not function properly if the
battery is not screwed in completely!
• If the unit does not function properly, remove
the battery and reinsert it as described above.
Seal
Status LED
Steady green light
Flashes green
Steady red light
Flashes alternately red and green
Power Level Display of the Handpiece
Power Level LED
Handpiece outside the charger
Steady green light
Battery is charged, handpiece ready for operation
Steady red light
Warning for low battery capacity, remaining capacity
adequate typically for 20 3-second cycles
Battery fully discharged, exposure cycle will be
Flashes red
completed or, if in extended mode, stopped
Handpiece/battery outside the charger
Charger ready for operation
n/a
Charge contact pins are wet
Malfunction in the charger
Power Level LED
Battery Charging
• The unit contains a powerful lithium-ion
rechargeable battery. The battery does not have any
memory effect and can therefore be recharged at
any time by placing it in the charger (see "Power
Level Display of the Handpiece" below).
• Alternatively, the battery in the unit can be replaced
by a spare battery (available separately) which has
been charged.
• Place the handpiece on the charger for approximately
1.5 hours before the first use, in order to charge the
new battery completely for the first time.
- The status LED showing the operating status of
the charger flashes green during the charging
operation; see below "Operating Status Display
of the Charger."
Operating Status Display of the Charger
Operating status
Handpiece/battery in the charger
Charging has been completed
Battery is being charged
Charge contact pins are wet
Problem during charging
Operating status
Handpiece in the charger
Not possible, handpiece is in sleep mode
Not possible, handpiece is in sleep mode
Problem in charging, battery is defective
or cannot be charged
Status LED showing
operating status
English
6