DSC Power Series Podręcznik - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik dla Ekran dotykowy DSC Power Series. DSC Power Series 18 stron. Neo image sensor
Również dla DSC Power Series: Podręcznik referencyjny (2 strony), Skrócona instrukcja obsługi (2 strony), Instrukcja instalacji (14 strony), Instrukcje instalacji (2 strony), Skrócona instrukcja obsługi (4 strony), Instrukcja instalacji (11 strony)

DSC Power Series PC1616 PC1832 PC1864 System Manual

If the Arming Inhibit for All Troubles features is enabled, Trouble Menu Acknowledgement may be used.

To use this feature while in the Trouble Menu ([*][2]), press [9] to acknowledge and override the existing

troubles, so the system can be armed. An override event will also be generated and logged, thus

identifying the user. To override open zones, use the Zone Bypass feature ([*][1]).

User Access Codes

In addition to the Master Access Code, you can program up to 32 additional User Access codes. Press [*]

[5], plus your Master Access Code. The Program or System indicator will begin to flash, and the Armed

(lock) indicator will turn on.

Enter the 2-digit number to be programmed (i.e., 06 for user access code 6; enter 40 for the Master

Access Code).

When using the PK5500/LCD5500, use the [< >] keys to find the specific code and press [*] to select.

Enter the new 4-digit access code, or press [*] to erase it. When programming is complete, enter another

2-digit code to program or press [#] to exit.

For systems using multiple partitions/areas, access codes can be assigned to specific or multiple

partitions/areas. Please contact your alarm company for details.

The minimum number of variations of access codes (key) is 27027 when 37, 6-digit user codes are used.

For SIA Installations, duplicate or duress codes derived from user codes +/- 1 digit are not allowed.

The access codes have programmable attributes which allow zone bypassing, remote access using the

ESCORT5580TC or one-time use activation.

Access Codes

[*][5][Master Code] (when disarmed)

The [*][5] User's Programming command is used to program additional access codes.

User Codes (Access Codes 1-32)

Master Code (Access Code 40) - The Master Code can only be changed by the Installer, if

programmed.

Supervisor Codes (Access Codes 41 & 42) - These codes are always valid when entering the User

Code Programming section. However, these codes can only program additional codes which have

equal or lesser attributes. Once programmed, the Supervisor Codes receive the Master Code's

attributes. These attributes are changeable.

https://alpha.adt.com/help/61[11/12/2018 9:40:17 PM]