DSE RE-BCC8FD Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kamera bezpieczeństwa DSE RE-BCC8FD. DSE RE-BCC8FD 3 stron.

OWNER'S MANUAL

REMOTE CONTROL VIA THE MENU UTC

If you have a UTC DVR you can control the camera menu

remotely via UTC protocol. The UTC control does not

require additional cables as controls passing along the

video cable.

For how to activate the UTC Command check DVR

manual.

REMOTE CONTROL VIA THE MENU RS485

The camera is equipped with an RS485 port that can be

used to remotely control the brightness of the illuminators

and the OSD menu. This way you can adjust all the

parameters remotely.

To send RS485 commands it takes a PTZ console or DVR

with RS485 port.

The settings to be set to communicate with the camera

are fixed:

Pelco D Protocol

SPEED '9600 bps

ADDRESS 1

The commands are sent to the camera by calling the

following presets

RE-BCC8FD camera license plate

DSE srl - Digital Surveillance Equipment - WWW.DSE.EU

CALL PRESET + 95 - Opens the OSD menu of the

camera

PROBLEMS AND SOLUTIONS

IR LED does not light up at night - Verify that there is

a source of light that illuminates the sensor on the rear of

the camera.

Glare on the plate - Avoid directly oriented towards the

camera lights (min 30 °).

The plate is moved- Check goal setting. Reduce the

shutter speed to 1/1000 or 1/1500

Targa too bright or dark at night - Adjust the power

of the LEDs according to the shooting distance

The power of LEDs varies after a reset - Confirm the

IR power settings to save it after adjustment

The plate is too small and you can not read -

Increase the zoom lens to focus the shot.

No video - Make sure your DVR supports the AHD 1080P

format.

Document: RE-BCC8FD 2C0

Page: 3