ATS Water boy Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe ATS Water boy. ATS Water boy 13 stron. Stage 3

11/10/2008

1000-102-930 - INST

Figure 5 – Water Boy Harness Socket Layout

Troubleshooting the Water Boy

The LED will not change from green and no stages are activating despite

the EGT reaching the setting for stage 1

The electronics box is not receiving the EGT signal. Make sure the pyrometer

wires are securely attached to the electronics board and that they are in the

proper ports. If the problem persists, double-check the wire connections that go

to the electronics board.

The LED goes through all stages, but it is not injecting water

Make sure the tank is mounted above the pump to help eliminate air-locking of

the system. Check to make sure the pump is properly grounded and that the

wiring is correct. Check the fuse that is inline with the relay's yellow wire. Check

the filter housing to see if it is clogged. If so, remove element, rinse until clean

and replace.

The system goes to stage 1, but will not go to stage 2 or 3

Stages 2 and 3 are boost dependent. The electronics box must see

approximately 10 psi and the set EGT level to activate stage 2, and

approximately 15 psi and the set EGT level to activate stage 3. If your vehicle is

meeting both boost and EGT requirements and still not activating, check to make

sure both ends of the boost line are securely attached and that the line is not

kinked.

The LED won't come on when the power is turned on

Check the black wire coming from the LED, is it properly grounded? Check the

fuse that is in line with the electronic box's red wire. Check the fluid level in the

tank as this can be an indication it is empty.