ATS Water boy Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe ATS Water boy. ATS Water boy 13 stron. Stage 3

11/10/2008

9. Find a suitable/visible location to mount the L.E.D. such as the dash or a

gauge pillar.

10. Drill a hole just large enough to fit the plastic sleeve through and push the

LED through to secure it. A 1/4" drill bit will work best.

11. Find a suitable location for the supplied power switch and install it. The

switch requires a 13/16" hole to mount properly.

12. Feed the four-wire group (Red, Black, Yellow, Blue) extending from the

Water Boy harness through a rubber grommet in the firewall into the cab.

13. Connect the Red wire of the four-wire group to the center terminal of the

switch with a spade connector. The wire should be labeled; "To Middle

Terminal Switch".

14. Connect the remaining three wires of the four-wire group to the L.E.D.

color for color.

15. Connect the supplied Black wire to the brass-colored terminal of the

switch with the spade connector. Connect the other end of the black wire

to a good ground under the dash.

16. Connect the supplied Pink wire to the remaining switch terminal and

attach it to a 12V source under the dash that is only energized when the

key is turned on. Use a voltmeter to find a suitable wire.

17. At a convenient location under the dash, cut the Pink wire connected to

the switch and splice in the supplied in-line fuse holder. Use the supplied

15A fuse.

18. Find suitable locations for both the pump and tank. Depending on the size

of the tank and the vehicle make, a spot under the hood might be hard to

find. If the tank cannot be mounted in the engine compartment, mount the

tank in the bed and the pump on the frame rail. Mount the tank above the

pump so that gravity will feed the pump (this will help eliminate "air-

locking" of the pump). If the tank will be mounted in the bed, mount it on

the same side as the intake manifold (Cummins- Driver's side, Duramax-

Passenger's side). This will make it easier to route the 3/8" plastic line.

1000-102-930 - INST