DSPeaker Anti-Mode X2 Podręcznik użytkownika - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt sieciowy DSPeaker Anti-Mode X2. DSPeaker Anti-Mode X2 12 stron.

Congratulations, your system has been optimized! Now it is a good time to put on some of your favorite

music and enjoy the improved sound.

Notice: The automatic calibration process targets a balanced overall sound, with slightly elevated

response towards the low bass region. The response can be adjusted in multiple ways to suit your

personal taste.

FOR BEST RESULTS: When calibrating a system with a subwoofer, set the built-in

lowpass filter of the subwoofer to bypass or to the highest available cutoff frequency.

With Anti-Mode the best place for a subwoofer is near a corner of the room.

PLEASE NOTE: After Anti-Mode gets rid of room resonances, it may appear that the

result sounds good, but is lacking in bass. You may have grown used to the exaggerated

bass response caused by room resonances. Listening for a while will accustom you to the

new more balanced sound.

If you feel that you need to increase the overall bass level, you can adjust the subwoofer

output level or use tone controls.

3.Hints and Tidbits

This chapter fills this page with some more or less useful trivia about the product, most useful first.

✔ In the 0.0 uncalibrated mode, the subwoofer output will reproduce the low-passed version of the

stereo outputs. There is no cross-over in this mode.

✔ In the 2.1 mode, the cross-over frequency is 80Hz.

✔ You can connect more than one subwoofer using daisy-chaining or a Y-splitter. The Anti-Mode

calibration is only concerned about the combined response of all of the speakers, subwoofers, and

the room. Use the same volume setting in each sub, you do not need to adjust them to appear

equally loud at the listening position. Only their combined response with the room matters.

✔ When there is no S/PDIF signal detected while the OPT or COX input is selected, the alternative

home screen shows three dots.

✔ You can select the ANA input while coaxial is connected and active without ill effects. If you have

the right analog input connected you can switch between right-channel-only analog mode and

coaxial two-channel mode. A more useful idea is to have an external RCA switchbox. (You can also

select the COX input while the stereo analog input is active without ill effects.)

✔ Infrasonic, Bass tone controls, and cross-overs are second-order filters, Treble tone controls are

first-order filters.

Rev. 1.1

(Adjustment will be possible in a later version.)

2022-08-10

-M

NTI

ODE

SER

UIDE

Page 10 (12)