Attero Tech unA4O AES67 Podręcznik użytkownika - Strona 7
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt nagrywający Attero Tech unA4O AES67. Attero Tech unA4O AES67 11 stron. Four output interface
Drukuj stronę2 – Device Installation
2.1 – Mounting
It is recommended that the unit be secured to a flat surface with a screw through each mounting flange. Dimensions for mounting are
show in the Figure 2 below. Use a No. 6 screw of a type and size that is applicable to the surface to which the unA4O will be attached.
*Notes for mounting: All connections to the unA4O should be
made before the power is applied.
Attach the outputs to the required audio devices. The
o
outputs are balanced so be sure to check what input type
the device to be connected requires in order to find how
to connect it correctly (see Hardware Connections section
2.3 for further details).
When powering using PoE:
Attach the network port to a spare PoE-enabled port on a
o
PoE switch using a CAT-5e/6 cable. If a mid-span injector
is being used, connect a spare input port to the audio
network switch using a CAT-5e/6 cable, and then connect
the corresponding output port to the network port of the
unA4O.
When powering using an optional external supply:
Attach the network port to a spare port on the audio
o
network switch using a CAT-5e/6 cable.
Attach the power supply to the power input jack and then
o
power up the external supply.
Figure 2 - Mounting Information
1315 Directors Row Suite 107 Fort Wayne, IN 46808 ⁞ (260) 496-9668 ⁞ www.atterotech.com
If all steps are performed correctly, the power light on the front
should be lit. Some of the status LED's may also be lit or flashing.
There may also be some activity on the unA4O Ethernet connector
LED indicators. With no network, both LEDs will remain off. If an
active connection is made both LEDs will come on and if there is
network activity, the yellow LED will then flash.
Page 7