Attero Tech unDIO2X2Plus Podręcznik użytkownika - Strona 12

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt nagrywający Attero Tech unDIO2X2Plus. Attero Tech unDIO2X2Plus 15 stron. 2x2 dante interface

Drukuj stronę

4 – 3

Party Control

The unDIO2X2+ supports 3

power, mic/line gain options and control of presets.

There are two control interface types available for the unDIO2X2+. The first type is a Dante proprietary interface which is

typically used by devices already that have built-in support for Attero Tech devices. The second type supports a 3

UDP interface and is available to anyone to use with any device capable of sending and receiving UDP messages.

Information on the commands the unDIO2X2+ supports as well as details of how to use the 3

be found in the unIFY 3

party Software API document, available from the registered users section of the Attero Tech

website (Go to

www.atterotech.com

4.1 – Command Interface Type

The type of command interface a specific unDIO2X2+ supports is defined by the Dante firmware it has been loaded with.

There are two methods to determine which Dante firmware and thus which command interface that is:

Run unIFY Control Panel V2.2 or later. Right-click on the device, and select the "Device Info" option. The interface

type is shown indicated by the "Control Type" field. A "-C" means the device is using the Dante Proprietary

interface. A "-U" means the device is using the 3

Using Dante Controller, double-click on the device in question, select the "Status" tab and look for the "Firmware

Version" parameter in the "Device Information" box. If the Firmware Version is V1.x.x, the device is using the

Dante Proprietary interface. If it's V2.0.0, the device is using the 3

A device's command interface can be changed simply by updating the device's Dante firmware. Moreover, this can be

done in the field in almost all cases. The tools and necessary firmware files for updating a device's command interface

can be obtained from the registered users section of the Attero Tech website (Go to

log-in option). The firmware files have an extension .DNT (otherwise known as "donut" files) and there is one for each

command interface type. The file with the –C in its name supports the Dante proprietary interface while the one with "-U"

in its name supports the 3

4.2 – Using the Command interface

In order to make use of the command interface, regardless of type, the unDIO2X2+ simply needs to be configured with

an IP address that is compatible with the device doing the controlling. The control devices should then be able to converse

with the unDIO2X2+ without any further configuration necessary.

 Attero Tech LLC 2018

party control allowing external system to manage the unDIO2x2's settings such as phantom

and click on the log-in option).

Party UDP interface.

party UDP interface.

party UDP control interface.

www.atterotech.com

Page 4

unDIO2X2+

User Manual

party

party UDP interface can

and click on the

614-00037 Rev 01_b