DST ObservAir Instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria DST ObservAir. DST ObservAir 20 stron. Distributed sensing technologies
Drukuj stronęDo not pressurize the sensor: Never connect the ObservAir to a
•
compressed gas cylinder (even when fitted with a regulator), air
compressor, or other pressure source without a purge valve that is open
to the atmosphere. Positive pressure air in the sensor can damage
sensing elements and other hardware.
Charger: Only charge the sensor with the included charger or
•
equivalent 2.1A rated USB charger. The included charger is rated for
operation at both 110V/60Hz and 220V/50 Hz – simply adapt to local
plug style if needed. Do not use chargers rated above 2.1A or below 2.0
A. The ObservAir can also be charged from computer ports that are
rated to at least 500mA.
Accessories: Do not use third party accessories with the ObservAir,
•
such as external battery packs, solar panels, etc. without first consulting
DST Technical Support.
Replacement parts: Only use replacement parts provided by DST or an
•
authorized DST distributor.
Disassembly: Never disassemble the unit, this voids the warranty and
•
may result in permanent damage to the unit and/or harm to the user.
Please contact DST Technical Support at
problems with your unit that cannot be resolved with the instructions
provided in this manual.
12
ObservAir Operating Manual
regarding any
3. Operating Instructions
3.1. Hardware overview
The ObservAir is shown in Figure 4 below. The sample air inlet and outlet
nozzles are located on the front panel, and are denoted by arrows facing
towards and away from each nozzle, respectively. The SD card slot and USB
port are also located next to one another on the sensor's front panel. In
Figure 4, the aerosol filter tab protrudes from its dedicated slot through the
front panel, as it does during normal operation. On top of the sensor, there
is a thumbscrew for securing the aerosol filter tab, and the interactive LED
button for sensor control and feedback.
Thumbscrew
SD card
Inlet nozzle
Aerosol filter tab
Figure 4. Overview of the ObservAir. Isometric view.
The serial number is engraved on the sensor's bottom surface. Please
include this serial number when contacting DST technical support.
Figure 5. Bottom view of the ObservAir
Interactive LED Button
USB Port
Outlet nozzle
Serial Number
ObservAir
Operating Manual
13
®