Boulevard DVP72LKR-1 Instrukcja instalacji

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria do kominków Boulevard DVP72LKR-1. Boulevard DVP72LKR-1 8 stron. Black glass liner kit

Drukuj stronę

LEAVE INSTRUCTIONS WITH THE APPLIANCE FOR FUTURE REFERENCE.

CARTON CONTENTS:

•

Rear Panel - Black Glass

•

Side Panel - Black Glass

(Qty. 2)

•

Bracket, Rear

Glass Panel (2)

•

Screw Package

•

Side Glass Panel

Bracket (Qty. 2)

•

Insulation

14-1/2" X 22-1/2" (Qty. 2)

INSTALLATION

Sharp edges! To avoid injury, wear safety gloves and

glasses to install liner.

1. Refer to the fireplace installation manual for removal

of the Barrier and Glass Door assemblies prior to

installation of the porcelain liner kit.

2. Remove decorative media from Hearth and burner cover.

3. Carefully unpack the black glass liners, verify that

all components are included, and inspect for hidden

damage, prior to installation.

4. Remove the front glass retainer (Hearth Ledge) by

lifting it up and out, then set it aside.

5. Install the two Side Glass Panel Brackets at the front

left and right side openings of the firebox with two

5/16 X 1/2" screws each. These brackets must be

installed so the "U" shape breaks are facing forward.

See Figures 1 and 2.

38219-1-0220

INSTALLATION INSTRUCTIONS

BLACK GLASS LINER KIT

DVP72LKR-1 - BLACK GLASS LINER KIT

FOR USE ON: DVLL72BP SERIES FIREPLACES ONLY

TOOLS NEEDED:

•

Gloves

•

Eye Protection

•

5/16" Hex Driver

CAUTION

SIDE

GLASS

PANEL

PANEL BRACKET

BRACKET

Figure 1

Empire Comfort Systems Inc. • Belleville, IL

6. Place one of the long Rear Glass Panel Brackets at

the back of the firebox and on top of the stainless steel

burner cover screen, then center it left to right. Place the

bracket against the rear wall with the long flange (with

holes) extending down behind the burner cover screen.

NOTICE: The two hand bend tabs located at each end

should be pointing upward at about 90 degrees.

7. Place one piece of insulation against the right side of

the firebox. Fold the 14-1/2" high piece of insulation

over on itself so the cut edges are toward the front of

the fireplace. When overlapped, leave approximately

a 5 to 6" difference between the front edges. Prop the

insulation against the side wall so the front edge is 2 to

3" from the front face of the firebox. See Figure 3.

SIDE GLASS

BRACKET

Figure 2

Figure 3

REAR

GLASS

REAR

PANEL

Page 1