DTAR Wave-Length Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przetwornik DTAR Wave-Length. DTAR Wave-Length 16 stron. Under saddle transducer

Installation

10. Select a location on the back or sides of the guitar and

secure the battery holder/power supply. Clean the surface

using rubbing alcohol before applying the Velcro.

11. Working from the inside of the guitar, insert the pickup

through the hole drilled in Step 4. Continue sliding

the pickup into the slot until it reaches the opposite end or,

in the case of a short saddle, until it slides into the

shallow hole that was drilled at the far end of the slot. (Refer

to note 5 under "Important Notes").

12. Insert the saddle into the slot. If you intend to adjust the

height, proceed to Steps 13 and 14. If you do not intend to

adjust the height, skip to Step 15.

13. Note the height of the previously scribed line in relation to

the top surface of the bridge. This is an indicator of the

amount of material that needs to be removed. Leave a

small amount of material (.005" to .010") to be removed by

hand sanding.

The preferred method is to use a vertical mill with a

sharp 1/4" diameter end mill turning at around 1000 RPM.

Set up your work carefully to ensure even material removal.

A second method is to use a belt sander with an

approx. 150 grit belt. Be careful to keep the saddle

perpendicular to the belt and remove material evenly from

the entire surface.

Installation Instructions