DTD CUB 18 Podręcznik - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik dla Instrument do nurkowania DTD CUB 18. DTD CUB 18 6 stron. Buoyancy compensator
Również dla DTD CUB 18: Instrukcja obsługi (18 strony)
Drukuj stronęthe bolt yet; the wing should be loose enough on the backplate to facilitate the assembly. Attach the wing in such
a way that the logo can be seen while looking at the backplate; that is, the wrap hose joint is on the opposite
side from the backplate.
Pass the straps with the buckle designed to hold the cylinder through a strap slot in the wing (1). The Velcro on
the strap must be turned to the outside, in the direction of the wing's perimeter. Continue by threading the strap
through a corresponding horizontal slot in the backplate (2), and then through a slot on the other side of the
backplate´s bending (3). Then thread the strap through a strap slot in the wing (4, 5). Move the strap so that the
Velcro close to the fastener runs through both strap slots of the wing. At the fastener, leave about 10 cm of the
strap without threading it through the wing. Follow the same procedure for the remaining strap and slots.
Passing the strap through the wing and the backplate:
After that pull the strap through the buckle in accordance with the following pictures:
Threading the strap through the belt buckle
Thread the strap through every opening in the buckle, as shown above.
This will ensure that the strap points backward and cannot become loose spontaneously
When finished, both parts of the Velcro should line up and ensure that the fastener does not unfasten.
If you do not change the wings on the backplate, we recommend bolting them to the backplate. You have already
used a bolt before threading the straps. Tighten it firmly, and do the same with the other one. The bolt head
should protrude above the eyelet in the wing as little as possible so that the surface of the cylinder does not get
damaged.