Attwood 7450 Series Instrukcje instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Oświetlenie morskie Attwood 7450 Series. Attwood 7450 Series 2 stron. 12-volt anchor/masthead light
Figure 4
#10 Pan Head
Screw
1/8" (3mm)
Pilot Hole
3/8" (10mm)
Wire Access Hole
CONNECT POWER TO SWITCH
Use ONLY the rated voltage. Higher voltage can damage light and
void product warranty. All positive (+) wires must be protected by
fuse (2-amp for 12-volt, 1-amp for 24-volt).
1. Use 3-position, double-pole OFF/ON/ON switch. (Figure 5)
2. From the anchor/masthead light, connect gray wire to one (+)
switch terminal. This switch position should operate all-round
anchor light (both lamps).
3. Connect blue wire to the remaining (+) terminal. This position
should operate forward masthead running light only (one lamp
forward) and all other navigation lights.
4. Test forward running and anchor lights for proper operation.
ATTWOOD LIMITED WARRANTY
ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan 49331
("Attwood") warrants to the original consumer purchaser that Attwood brand
products will be free from defects in materials and workmanship under normal
use and service for one year from the date of original consumer purchases.
This limited warranty is not applicable if the product has been damaged by
accident, improper installation, unreasonable or improper use, lack of proper
maintenance, unauthorized repairs or modifications, normal wear and tear,
or other causes not arising out of defects in materials or workmanship.
Attwood products are warranted for use on pleasure boats. Any other
use—including but not limited to commercial, racing, or non-marine
use—are not covered under this warranty. Attwood's obligation under this
warranty is limited to repair of the product at Attwood's plant or replacement
of the products at Attwood's option without expense to the original consumer
purchaser. Any expenses involved in the removal, reinstallation or
transportation of the product are not covered by this warranty.
The product must be returned to Attwood's plant at the address above,
postage pre-paid, and insured with proof of original purchase including date.
If Attwood is unable to replace the product and repair is not commercially
practical or cannot be timely made, or if the original consumer purchaser is
Black Wire to Ground (-)
Blue Wire (+)
Mast Light (Forward)
Gray Wire (+)
Anchor Light (Aft)
Figure 5
In Line Fuse Holder
(pos)
(neg)
Battery
Black
Gray (pos-1)
(To Negative)
Anchor Forward
(All Around)
MAINTENANCE
1. To replace lens or lamps, remove top retaining screw and lens.
2. Replace lens with Attwood #912896.
3. Replace lamp(s) with Attwood #9230 (12-volt), #910409 (24-volt).
4. Reinstall lens and retaining screw.
5. To adjust tension on cam-lock adjustment handle: Use Phillips
screwdriver to loosen screw in center of handle (Figure 2). Adjust
tension so handle releases easily, and also holds light in position
when locked.
willing to accept a refund in lieu of repair or replacement, Attwood may refund
the purchase price, less an amount for depreciation. The acceptance by
Attwood of any product returned or any refund provided by Attwood shall not
be deemed an admission that the product is defective or in violation of any
warranty. Products that are replaced or for which a refund is issued become
the property of Attwood.
THIS WARRANTY IS ATTWOOD'S ONLY EXPRESSED WARRANTY OF
THESE PRODUCTS. NO IMPLIED WARRANTY INCLUDING, WITHOUT
LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, SHALL BE EXTENDED BEYOND
THE WARRANTY PERIOD STATED ABOVE FOR EACH PRODUCT. ATTWOOD
SHALL NOT BE LIABLE FOR ANY DAMAGES, FOR LOSS OF USE OF THIS
PRODUCT, NOR FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL
DAMAGES, COSTS, OR EXPENSES.
Some states do not allow limitations on how long an implied warranty lasts or
the exclusion or limitation of incidental or consequential damages, so the above
limitations and exclusions may not apply to you. This warranty gives you specific
legal rights, and you may have other rights which vary from state to state.
© 2004 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260
3-Position Switch
(Off/On/On)
Blue (pos-2)
Forward Running
www.attwoodmarine.com