AddEnergie SmartDC Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Ładowarka AddEnergie SmartDC. AddEnergie SmartDC 15 stron. V2

Security

IMPORTANT SAFETY INSTRUCTIONS-PLEASE DO NOT DISCARD THESE INSTRUCTIONS

Carefully read this guide before installing the EVSE .

1 . This station was designed to be ground-based and installed on a non combustible surface .

2 . Make sure with local authorities that the location where the EVSE is to be installed is free from

underground pipelines or electrical equipment, otherwise you might inflict yourself serious injuries .

3 . Connect the power supply of the station with copper or aluminum conductors sized in conformity

with the local code for a three-phase, 480Y/277V, 54kVA circuit, rated for usage at a maximum

temperature of at least 75°C .

4 . Grounding: to ensure the safe operation of the station, it must be connected to a grounding circuit

compliant with local regulations and installed by a certified electrician .

5 . Communicate with a certified contractor, certified electrician or trained installer to ensure compliance

with local building code, regulation, security standards and weather conditions .

6 . Any alteration of a part of the station will automatically void the warranty .

7 . Handle parts with care, since they can be sharp-edged . Always use safety glasses and gloves when

unpacking and installing .

8 . Some parts are heavy and could cause injury . Use proper lifting techniques and wear safety boots at

all times during the installation .

9 . Never insert your fingers into the electric vehicle's connector .

10 . Never use the station if the flexible power cords seem damaged, or if the insulation is damaged .

11 . Never use the station if the main case is broken, cracked, open, or damaged .

12 . This station was designed to be used with electric vehicles equipped with a CHAdeMO or SAE

J1772 Combo port .

13 . This station is to be used to charge vehicles that do not require a ventilated environment during

charging .

14 . Replacement of the station's parts must be performed by qualified service personnel .

15 . Do not install the station on or over combustible surfaces .