Comtrend Corporation GCA-6000 Podręcznik szybkiej instalacji - Strona 2
Przeglądaj online lub pobierz pdf Podręcznik szybkiej instalacji dla Adapter Comtrend Corporation GCA-6000. Comtrend Corporation GCA-6000 2 stron. G.hn ethernet over coax adapter
Drukuj stronę
C
Adding your G.hn Coax Adapter to an Existing G.hn Coax Network
4. Plug the power supply into the Coax Adapter and into the power outlet nearest to the remotely located Internet-enabled
device (Eg. TV, PC, STB, DVR, Etc.).
5. Connect the coaxial cable to the "IN" of the Coax Adapter and to a cable wall outlet.
6. Connect the Coax Adapter to the device with an Ethernet cable. The Ethernet LED
GREEN. The Coverage LEDs
strength of the connection.)
Coaxial Cable
Note: The "TV" port on the Coax Adapter is meant for traditional Cable TV services. We do not recommend using the Coax
Adapter if you receive Cable TV/Internet services.
7. We recommend a secure network. If the Security LED
seconds consecutively (until the Security LED
button is pressed. Upon successful connection of the Adapters, the Security LED
light up
GREEN,
ORANGE, or
Note: Pressing the Config button – located on the side of the device for more than 5 seconds resets the security settings (10
seconds or more performs a factory reset). If you accidentally reset the GCA-6000 unit, repeat step 7 to secure the network.
8. If the connection process is not successful, please refer to the trouble shooting steps in section F.
Adding Additional Adapters/Devices
D
Follow steps 4-8 in Part C to add additional Adapters/devices to the Coax Network (up to 32 devices). For each additional
adapter added, press the "Config" button on an already secured Adapter, then on the new adapter, so they can pair and
transmit data successfully.
E
Your device is now part of a G.hn Coax Network!
F
Troubleshooting
The following information should help you diagnose basic setup or installation problems.
COVERAGE LED
is OFF: Plug the problem GCA-6000 unit into a power outlet next to the other GCA-6000 unit; both GCA-6000
having been connected by Ethernet cable to their respective devices e.g. PC, Router, Set Top Box....etc.). After 10 seconds
(approx), the COVERAGE LED
each for more than 10 seconds. Then, go to part B and follow the installation steps.
ETHERNET LED
is OFF: If the ETHERNET LED
the LAN port of the other device. To check the condition of the Ethernet cable, use another cable to test the same connection.
FOR MORE HELP: For instructions on advanced features, FAQ, etc., please visit our online Product Webpage
http://us.comtrend.com/products/public/product/home-networking/gca-6000.html
For more information:
Facebook:
https://facebook.com/Comtrend
Website:
http://us.comtrend.com/
Support: Visit our website or call 1-877-COMTREND (1-877-266-8736)
on the Coax Adapters should now be lit (they will be
Power Adapter
starts blinking). You will have 2 minutes to complete this step once the first "Config"
RED.
should light up GREEN. If not, first Factory reset both devices by pressing the "Config" button on
fails to light up, check that the LAN port of the GCA-6000 unit is connected firmly to
GREEN,
Ethernet Cable
IP Set-Top-Box, Game Console, Streaming Media Player, etc.
is off, press the "Config" button on each of the two Coax Adapters for 3
will light up
on the Coax Adapter should be flashing
ORANGE, or
RED
depending on the
HDMI Cable
GREEN
and the Coverage LED
will
Page 2