ATZ HDBaseT HDBT-E150B-18 Podręcznik - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik dla Kable i złącza ATZ HDBaseT HDBT-E150B-18. ATZ HDBaseT HDBT-E150B-18 12 stron. 1x8 splitter hdmi 2.0b, hdr10+, 18g, support 4k@60hz (150m) c/w 8x receivers

Drukuj stronę
Model
: ATZ HDBT-E150B-18
Description: HDBaseT™ 1x8 Splitter HDMI 2.0b, HDR10+, 18G, support 4K@60hz
(150m) c/w 8x Receivers

ASCII Commands

The product also supports ASCII command control. Connect the RS-232 port of the product
to a PC with a 3-pin phoenix connector cable. Then, open a Serial Command tool on PC to
send ASCII commands to control the product. The ASCII command list about the product is
shown as below.
Serial port protocol. Baud rate: 115200, Data bits: 8bit, Stop bits:1, Check bit: 0
x - Parameter 1 y - Parameter 2
! - Delimiter
Command
Function Description
Code
Power
Power on/off the
s power z!
device,z=0~1 (z=0 power
off, z=1 power on)
r power!
Get current power state
s reboot!
Reboot the device
System
Setup
help!
List all commands
r type!
Get device model
r status!
Get device current status
r fw version! Get Firmware version
Get the connection status
r link in!
of the input port
Get the connection status
r link out y!
of the y output port,
y=0~9(0=all, 1~8=HDBT
1~8, 9=loop out)
s reset!
Reset to factory defaults
Command
Function Description
Code
Output Setting
Set hdmi loop output
s hdmi
stream on/off
stream z!
z=0~1(0:disable,1:enable
)
Notes
: - All brand names and trademarks are properties of their respective holders and are referred to here for descriptive purpose only. Photo attached is for reference only, it may be slightly varied in items of colour, shape from the actual item delivered
from time to time.
ASCII Commands
Example
Feedback
Power on
s power 1!
System Initializing...
Initialization Finished! FW
version x.xx.xx
r power!
power on/power off
Reboot...
s reboot!
System Initializing...
Initialization Finished! FW
version x.xx.xx
help!
r type!
HDC-SPB18H150
Get the unit all status:
power,
r status!
in/out connection, edid
mode
MCU BOOT: Vx.xx.xx MCU
r fw version!
APP: Vx.xx.xx
r link in!
HDMI IN: connect
hdmi loop out:
connect
r link out 1!
hdbt output 1: connect
Reset to factory defaults
s reset!
System Initializing...
Initialization Finished! FW
version x.xx.xx
Example
Feedback
Enable hdmi loop out
s hdmi stream 1
stream
!
Disable hdmi loop out
stream
pg. 8
All specifications are subject to change without prior notice.
© Copyright ATZ
Default Setting
power on
Default Setting
enable