AIRTRONICS VG4R Instrukcja obsługi

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Pilot zdalnego sterowania AIRTRONICS VG4R. AIRTRONICS VG4R 6 stron.

Airtronics Vanguard Radio Control Operating

Refer to the diagram showing the radio control transmitter for the location of controls.

Extend the Radio Control Transmitter Antenna 1/4 to 1/2 way. Turn the Radio Control

Transmitter on first and then turn on the main robot power switch. Turn on the Bear. It is

necessary for the robot to always have an operating signal when it is on. If there is no signal

you will not have full control of the robot.

Before operating the robot, attach the neck strap to the radio control neck strap

connecting hook (#10 on the radio control diagram).

Control of the left and right eyelids is via switch #11 and #12 (See the radio control

diagram) found on the upper left hand corner of the Radio Control Transmitter. With the

switch towards the operator the eyelids will be in the closed position and away from the

operator the eyelids will be in the open position. The movement of the eyes left and right is

operated by switch #13. Moving it left moves the eyeballs left and moving the switch right

causes the robot eyes to look right.

The cassette/radio and siren is controlled by the switch on the upper right top of the

radio control (switch #18). Movement of the switch away from the operator causes the

cassette tape function to switch on. Movement of the switch towards the operator causes

the siren to switch on.

The left joystick left and right moves the Bear's head. Forward and back movement

of the joystick does not control a function.

A charge plug is provided on the transmitter for recharging its internal 500 mAH NiCd

batteries ( Do not use this charge plug to charge the optional 1.3AH super battery pack ).

The charger should be connected with the appropriate cable connection, and the transmitter

power switch must be in the off position before charging the batteries. A charge light on the

charger will come on while charging.

To charge the super battery, unplug it from the R.C. and connect it directly into the

super battery charger. Do not charge the small RC battery with the super battery charger.

The small battery must be charged through the RC.

The transmitter should be charged for 16 hours when fully discharged. Take care not

to overcharge the batteries as this will shorten their life span. Repeated partial discharging

of the NiCd batteries will cause them to lose some of their capacity. Therefore, it is

preferable to discharge the transmitter until the needle goes into the red region of the battery

level meter before recharging when this is possible. It is best to avoid discharging the

batteries until they are completely dead as this will make recharging more difficult.

The optional 1.3AH super battery pack may be attached to the back of the radio

control with the Velcro. To connect it to the radio control, open the battery compartment of

the radio control. Disconnect the internal RC transmitter Battery, and connect the Super

Battery connector where it was plugged into. Put the battery compartment door back on

allowing the Super Battery wire to run through the slot.

Instructions