Auber Instruments SYL-1615SYS-W Skrócona instrukcja obsługi

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Kontroler temperatury Auber Instruments SYL-1615SYS-W. Auber Instruments SYL-1615SYS-W 2 stron. Charcoal smoker controller

Drukuj stronę

Quick Guide for Charcoal Smoker Controller SYL-1615

This SYL-1615 temperature controller is for charcoal smokers. To operate it, connect the 12 VDC power adapter to the POWER

INPUT connector (①) and wall outlet. Connect the fan connector to the OUTPUT connector (②). The polarity for this socket is

center pin positive (+), outer collar negative (−). Connect the type K thermocouple to the INPUT socket (③). Please note that

thermocouple connector also has polarity. The wide blade should go to wide slot.

Application Tips

Lower Vents. The temperature in a Smoker/BBQ pit is mainly affected by two factors: the fuel and the air flow. When you

use a PID controller and a blower on a BBQ or smoker, the goal is to let the controller to take over the control of the air

flow. So, if there were multiple lower vents on the smoker, use one of them to mount the blower, and fully close all other

lower vents. If there is a big gap between the blower and the vent, please seal the gap with a piece of aluminum tape or a

silicone gasket.

The top vents should be closed down a little bit than you normally would when cooking without a controller and blower. For

WSM, we recommend setting the top vent to 1/4" wide. For Kamado style smokers such as the Big Green Eggs, the top

vent opening needs to be set very small. To maintain the cooking temperature at the lower range (around 225° F), please

close the bottom vent completed and only open the top vent to about 1/16'' (1.6 mm).

The default PID parameters (Change P = 1.2, I = 300, D = 70) are optimized for charcoal smokers. Normally users don't

need to change them. But if you are experiencing big temperature oscillation, you can try another set of PID parameters

which makes the controller approach the target temperature more gently. Please set P = 1.8, I = 1200, D = 70. You'll also

need to adjust another parameter SF (under access code 0037) and set it to SF = 30. Please DO NOT change other

parameters under this code. If you need further information about how to fine tune the controller or access the parameters,

please refer to the instruction manual.

The thermocouple cable is food grade, which is insulated by TEFLON (PFA) with stainless steel over braid. The maximum

working temperature for the cable is 500° F. Please do not drop the cable on top of the flame or drape it over the fire box.

Set the target temperature. There are two ways to set the target temperature:

a. During the normal operation mode, press Λ or V once to switch the display from process value (PV) to set value (SV, or

target temperature). The display will start to blink. Press Λ or V again to increase or decrease the SV. When finished, wait

8 seconds and the setting will take effect automatically (the display will stop blinking).

b. Press SET key once. Use >, Λ and V keys to enter code 0001. Press SET key to confirm, then the display would be SV

(Su). Press SET key again to display the SV setting. Use >, Λ and V keys to enter the new SV and press SET to confirm.

No part of this manual shall be copied, reproduced, or transmitted in any way without the prior, written consent of Auber Instruments. Auber

Instruments retains the exclusive rights to all information included in this document.

Version 1.2

(May, 2017)

Figure 1. Controller connector identification.