Auber Instruments WS Series Skrócona instrukcja obsługi
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Kontroler temperatury Auber Instruments WS Series. Auber Instruments WS Series 14 stron. Programmable pid temperature controller with dual probe
Również dla Auber Instruments WS Series: Skrócona instrukcja obsługi (15 strony), Skrócona instrukcja obsługi (14 strony), Instrukcja obsługi (18 strony), Instrukcja obsługi (18 strony)
Drukuj stronę
Programmable PID Temperature Controller with Dual Probe
Introduction
Thank you for purchasing the Auber WS series temperature controller. We sincerely
appreciate your decision and trust that our machine will meet your expectations in both
the quality of the result and the value of our product. While we are delighted that you may
be anxious to operate the controller for your project, a few minutes of your time reading
through this manual will only serve to enhance your experience in the months and years
ahead. In particular, we urge you to read through the safety warnings below. Although
this plug-and-play controller is very easy to operate, the process involves high
temperature and high wattage appliances and your safety is paramount.
This controller is designed only to be used with devices that have limited power
and their own thermal cut off protection, such as a thermostat or thermal fuse in
case of controller failure.
Do not place any objects on the top of the controller surface as it is used to vent
excess heat during its operation.
The maximum electric current this controller can handle is 13 ampere. For 120
volt AC in US and Canada, this limits the heater power to 1450 watts.
Always place the sensor in the controlled subject when the controller is on. Before
turning on the controller, please make sure the sensor is placed inside the
container to be controlled. Leaving the sensor outside of the solution will form an
open loop operation, and the controller will assume the temperature is low even if
the controlled subject is already very hot. The controller will provide full power to
the heater which will not only overheat the controller, but also damage your
appliance possibly causing a fire.
This controller is designed to control the devices recommended by Auber
*
Patent pending
Quick Guide for WSD-1200GPH
Version 1.3 (Oct, 2015)
Auber Instruments
5755 North Point Parkway, Suite 99
Alpharetta, GA 30022
770-569-8420
www.auberins.com
SAFETY WARNINGS
1
*