Auber Instruments JSL-64A-EST Podręcznik aplikacji

Przeglądaj online lub pobierz pdf Podręcznik aplikacji dla Timer Auber Instruments JSL-64A-EST. Auber Instruments JSL-64A-EST 2 stron.

Auber Instruments, Inc.

Introduction

In this document, we will show you the idea of how to use the JSL-64A-EST timer as an espresso-shot-timer on

your home espresso machine. This application guide is based on a home espresso machine that requires 120VAC

power and is installed with a vibration pump also requires 120VAC. If you have an espresso machine and a

vibration pump that require 240VAC, you'll need to use a relay with 240V coil voltage.

Parts

JSL-64A-EST timer

R30A relay (120VAC coil voltage, and one pair of normally open relay contacts)

Wires, 6 pieces

Wiring

Connect the timer, R30A relay, and the vibration pump as shown in the Figure 1 below. Please note that the red

lines and black lines indicate wires that carry 120VAC, while the blue lines indicates the wires only carry low

voltage signal. Wires attached to pin 1 and 2 on the JSL-64A supply 120V power to the timer. Tap these two wires

to the power button of your espresso machine.

Figure 1. Connecting JSL-64A, relay, and the vibration pump together.

Timer Setting

To use this timer as an espresso shot timer, please set the timer function FUNC = EST, and the timer unit T1u = S.

Then press the RST key to clear the screen. The display will show "0.00" as shown in the Figure 2 below. Please

refer to the manual of JSL-64A for details on how access the parameters.

JSL-64A-EST Application Guide

Version 1.0 (April 2020)

Pump

Original

wires on the

pump

(120VAC)

Mimi Relay

R30A

COM

JSL-64A Timer

To 120 VAC