Auber Instruments DSPR-5 Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria Auber Instruments DSPR-5. Auber Instruments DSPR-5 6 stron.

Drukuj stronę

Auber Instruments, Inc.

MmOL

MMOL

Manual

mode open‐

loop

mSV

Maximum

Set Value

VER

Firmware

version

rst

RST

Factory reset N, Y

9. Reset the Timer

Important Note: this operation is only available to situations:

1) when the timer function is enabled (i.e., parameter "TF" is set to "on") AND

2) when the account‐down timer has been triggered (i.e., after the PV has reached the SV).

To reset the timer, press down the knob briefly, the controller will show "TRST" in the top window

and show "n" in the lower window. Turn the knob to change the letter in the lower window to "y" and

then press down the knob to reset the timer.

Timer Reset ("tRST")

Name

Symbol Description

trst

TRST

Timer reset

(End)

No part of this manual shall be copied, reproduced, or transmitted in any way without the prior, written consent of Auber Instruments. Auber

Instruments retains the exclusive rights to all information included in this document.

Y, N

0 ~ 2372

932

Range

Default

N, Y

Auber Instruments, Inc.

5755 North Point Parkway, Suite 99,

Alpharetta, GA 30022, USA.

www.auberins.com

E‐mail: [email protected]

Tel: 770‐569‐8420

Page 6 of 6

Enable output in open‐loop situation (sensor failure

or no sensor is connected). Only applies to manual

mode.

N: disable output in open‐loop situation (i.e., no

sensor is connected).

Y: enable output in open‐loop situation.

The upper limit of temperature SV.

Firmware version number. Display only.

(Current firmware ver1.2.1)

N: no action.

Y: reset all parameters to factory default values.

Note

N: No action.

Y: reset the timer.