Auber Instruments RTDstat Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Akcesoria do urządzeń kuchennych Auber Instruments RTDstat. Auber Instruments RTDstat 2 stron. Select the correct sensor for rancilio silvia

Drukuj stronę

Auber Instruments RTDstat Skrócona instrukcja obsługi

Auber Instruments, Inc.

Figure 2. The factory sticker usually can be found on the base (left), and the manufacture month and

year are printed in the lower right corner of the sticker (right).

Step 2: Check the Boiler -- The Most Reliable Way

The most reliable way to tell if the boiler can take the PT100M4 screw sensor is to open up the

machine and directly check the boiler.

Tools Needed

Phillips screwdriver and flat-head screw driver.

Remove the water tank, remove the four screws on the top of the Rancilio Silvia, and then remove the

top cover. There are two thermostats on the top of the boiler, each thermostat is held in place by a clip

with two screws on each side. Pick one of the thermostats, use the flat-head screwdriver to loosen the

screws. Be careful not to drop the screws or the clip. Once you can lift the thermostat, you can see the

boiler surface beneath it. The photos in Figure 3 are two examples from our customers.

Figure 3. Two examples of boilers with M4 screw holes at where thermostats are installed.

Please

for any questions.

(End)

No part of this manual shall be copied, reproduced, or transmitted in any way without the prior, written consent of Auber Instruments. Auber

Instruments retains the exclusive rights to all information included in this document.