3onedata TNS5800D Instrukcja szybkiej instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja szybkiej instalacji dla Przełącznik 3onedata TNS5800D. 3onedata TNS5800D 5 stron. 12-port series layer 3 wall mounting industrial ethernet switch

Drukuj stronę
This
10/100Base-T(X)
the interface type is M12 D-
Coded 4-Pin slot (female).
Single port supports up to 30W
PoE power output, PoE power
supply Pin 1 and 3 are positive, 2 and 4 are negative, and M12
pin is defined as follows:
Pin No.
Pin Definition
Description
1
TD+
Positive send data of 100M
Ethernet
2
RD+
Positive receive data of
100M Ethernet
3
TD-
Negative send data of
100M Ethernet
4
RD-
Negative receive data of
100M Ethernet
Gigabit M12 interface
This series of device provides 10/100/1000Base-T(X)
interfaces, the interface type is M12 X-Coded 8-Pin slot
(female). Two groups of Bypass interfaces are supported, in
which G1 and G2 are a group and G3 and G4 are a group.
The pin definitions of M12 are shown as follows:
Pin No.
Pin Definition
Description
1
GE0+
Positive bi-directional
data of Gigabit Ethernet
group 1
device
provides
Pin No.
interfaces,
2
3
4
5
6
7
8
【Checking LED Indicator】
The series of devices provide LED indicators to monitor its
operating
troubleshooting process. The function of each LED is
described in the table below:
LED
P1/P2
ALM
Pin Definition
Description
GE0-
Negative bi-directional
data of Gigabit Ethernet
group 1
GE1+
Positive bi-directional
data of Gigabit Ethernet
group 2
GE1-
Negative bi-directional
data of Gigabit Ethernet
group 2
GE3+
Positive bi-directional
data of Gigabit Ethernet
group 4
GE3-
Negative bi-directional
data of Gigabit Ethernet
group 4
GE2-
Negative bi-directional
data of Gigabit Ethernet
group 3
GE2+
Positive bi-directional
data of Gigabit Ethernet
group 3
status,
which
has
simplified
the
Indicate
Description
P1/2 is connected and running
ON
normally
P1/2 is disconnected and
OFF
running abnormally
ON
Port link has alarm
OFF
Port link has no alarm
ON
RUN
OFF
Blinking
ON
LINK(E1-
E12, G1-
Blinking
G12)
OFF
POE(E1-
ON
E8, G1-
G8)
OFF
【Logging in to WEB Interface】
This series of devices supports WEB management and
configuration, and computers can access devices through
Ethernet interfaces. The way of logging in to device's
configuration interface via IE browser is shown as below:
Configure the IP addresses of computer and the
device to the same network segment, and the
network between them can be mutually accessed.
Enter device's IP address in the address bar of the
computer browser.
overall
Enter device's username and password in the login
window as shown below.
The device is powering on or the
device is abnormal.
The device is powered off or the
device is abnormal.
Blinking 1 time per second,
system is running normally
Ethernet port has established a
valid network connection
Ethernet port
is in an active
network status
Ethernet port has not established
valid network connection
POE port is powering other PD
devices normally
POE port is not powering other
PD devices