Conair TT228C Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Stylista włosów Conair TT228C. Conair TT228C 8 stron. Nano titanium tourmaline ceramic styler

14. While using the appliance, keep your
hair out of it. Keep your hair away from the
air inlets.
15. Do not use with voltage converter.
16. CAUTION: when adjusting airflow setting
to diffuser, surface area may be hot. Allow
to cool in between settings.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
This appliance is intended for household
use only. Use on Alternating Current (60
hertz) only. Standard Dryers are designed
to operate at 110 to 125 volts A.C.
This appliance has a polarized plug (one
blade is wider than the other). As a safety
feature, this plug will fit in a polarized out-
let only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician.
Do not attempt to defeat this safety feature.
IMPORTANT
1875 WATT OPERATING GUIDE
Use of this dryer on the same circuit or fuse
with other electrical products or appliances
may trip a 15 amp circuit breaker or blow a
15 amp fuse. NEVER replace the fuse with
one rated higher than the capacity of the
circuit. Doing so could result in an electri-
cal fire.
SUPER STYLING GUIDE
Your best looks begin with a good haircut
that's well maintained. Always treat hair
right with superior quality shampoos, con-
ditioners, and finishing products.
DRYING BASICS
1. Shampoo and condition hair with products
of your choice. Rinse thoroughly. Towel dry
hair to remove excess moisture. Using the
dryer along with your styling brush, start
at a lower setting and direct hot air through
a section of hair at a time. Move dryer
steadily across each section so that the hot
air passes through hair. Direct air flow at
hair not scalp. Clouds of negatively charged
ions will help to reduce static electricity,
control frizzy flyaways and contribute to
your hair's shine.
2. Keep dryer's air intake vents unobstructed
and free from hair while drying.
3. To avoid over drying, do not concentrate
heat on any one section for any length of