dams Elev82 Mono Single Desk EVM-1600 Instrukcja montażu - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Wyposażenie wnętrz dams Elev82 Mono Single Desk EVM-1600. dams Elev82 Mono Single Desk EVM-1600 8 stron.
Drukuj stronę
12
Step 12
It is now time to lift the desk over into its upright position. This is a 2 person lift, do not attempt
to do this without assistance as this could result in injury or damage to the product.
13
Step 13
Your desk is now ready to be connected to the mains outlet.
Before you proceed with operating your new desk it is recommended that you perform a full
reset of the controller to calibrate the height of each leg.
This can be done using the following steps;
Press button down for 3 seconds.
•
Continue pressing the button until both columns are in lowest position.
•
Keep pressing the button until control box makes 1 beep.
•
When control box makes 1 beep, it is confirmed that reset has been completed and button
•
can be released.
Now the desk is operational.
•
If the desk is disconnected by accidently pulling out the plugs at the control box, motors,
•
handset, main power source
or system status reach overload, overheat etc. then the desk must be reset.
•
If the desk is powered off intentionally at the main power switch, then the desk does not
•
need to be reset.
Operating the desk
Press the button, to operate the desk for upwards running.
Press the button, to operate the desk for downwards running.