Conairphone TAD2012 Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Automatyczna sekretarka Conairphone TAD2012. Conairphone TAD2012 16 stron. Callkeeper digital answering system
Drukuj stronęInstallation
CAUTION
1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
3. Never touch uninsulated telephone wires or terminals unless the incoming
telephone line has been disconnected at the network interface.
4. Use caution when installing or modifying telephone lines.
Note:
Refer to "FCC Requirements" section before connection to telephone line.
To Install One 9 Volt Battery
One 9 volt battery (not included) is required
to maintain your personalized greeting and
recording messages during a power failure.
If there is a power failure and the battery is
not installed, both your personalized
greeting and recorded messages will be lost.
1. Make sure the AC Adaptor is unplugged
from the electrical outlet.
2. Use a pen or paper clip to loosen the
battery cover. Open the battery
compartment by pressing down on the
battery cover and sliding it away from the
unit. (Fig A)
3. Install one 9 volt battery.
4. Replace battery compartment door.
Note:
Install a replacement battery once a year to
insure proper operation of the power failure
protection feature.
The battery status is indicated by the
BATT. LOW indicator. If a fresh battery
is installed, the LED indicator stays lit
solid. If the battery is low/not installed,
the indicator will flash.
Choosing Your Location
Before making any connections, locate
TAD2012 near an AC power outlet
and a wall telephone jack (RJ11C).
Desk or Table Installation
1. If you are connecting your TAD2012
to an extension telephone, plug one end
of The extension telephone line cord to
the extension line jack (located on back
Figure A
of unit). Plug the other end into the
telephone.
2. Plug the telephone line cord
(connected to the back of the TAD2012)
into the modular outlet in your telephone
wall jack.
3. Connect the AC adaptor into the back
of the unit. Plug the other end into the
AC wall power outlet. Do not attach
(staple, etc.) the AC Adaptor cord to the
building wall (Fig. B).
6