dams TGSMARM-WH Instrukcja instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Stojaki i stojaki dams TGSMARM-WH. dams TGSMARM-WH 2 stron.

Drukuj stronę

STEP 5

Adjust the monitor

Please do not fully reverse the

monitor screen-to prevent

Caution

damage to the fixings.

Factory setting: 5-7KG

To equalise the mount and

monitor's weight-please

Cable management

take off cable

Cable

management

To adjust the swivel function by 5*5 allen key(F) on position 1

To adjust the tilt function by 5*5 allen key(F) on position 2

Specification

360°

100

±90°

-90°

15°

ut cable

a a e e t

back to cover the cables

This product contains small items that could be a choking hazard if swallowed. Keep these items away from young children.

● Make Sure these instructions are read and completely understood before attempting installation. If you are unsure of any part of this installation, please contact a professional

installer for assistance.

● The desk or mounting surface must be capable of supporting the combined weight of the mount and the display,otherwise the structure must be reinforced.

● Safety gear and proper tools must be used. A minimum of two people are required for this installation. Failure to use safety gear can result in property damage, serious inju ry or

death.

● please check joint parts every two months, making sure the screws are nor loosened.

This product was designed to be installed on a desk. Before installing, make sure the mount will support the combined load of the equipment and

hardware. Never exceed the maximum load capacity 12 KG, or else it may result in product failure or personal injury.

Note:this product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal injury.

Warning:

This product contains high pressure gas spring parts, please do not put it into fire, high temperature, or disassemble it, which will lead to

personal injury. The

obsolete products can be sent back to the manufacturer or handed over to professional institutions.

To maintain the gas mechanism in peak performance - it is suggested to raise the monitor arm up to the maximum height: ideally twice per month.

Max:622

179

±180°

±135°

CAUTION