Dan D'Agostino Momentum Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Dan D'Agostino Momentum. Dan D'Agostino Momentum 13 stron. Hd preamplifier
Również dla Dan D'Agostino Momentum: Instrukcja obsługi (13 strony), Instrukcja obsługi (10 strony), Instrukcja obsługi (15 strony), Instrukcja obsługi (11 strony), Instrukcja obsługi (11 strony)

MAKING CoNNECtIoNs to thE

MoMENtUM stEREo AMPlIFIER

Install the speaker cables first. We recommend the use of high-quality cables terminated

with spade or ring lugs that will fit the Momentum Stereo's binding posts. We advise against

the use of pin connectors, banana plugs, or bare-wire connections.

Note that the positive (+) binding post has a red ring and the negative (-) binding post has a

black ring. Double check to confirm that you are connecting your speaker cable's conductors

to the appropriate binding posts—red to positive, black to negative. If your cables are marked

to show desired signal flow, orient the cable so that the installation conforms to the cable

manufacturer's instructions.

To install speaker cables tipped with spade lugs or rings, use the supplied binding post

wrench to carefully loosen each speaker binding post. Turn counter-clockwise to loosen. If

using spade lugs, insert each spade lug so that its two tines straddle the binding post, then

tighten the binding post nut with the binding post wrench. If using rings, remove the binding

post nut, place the ring on the binding post, then replace the nut and tighten it securely.

A firm connection, tight enough that the spade lug or ring cannot move, is all that's needed.

Overtightening could damage the binding posts. Do not use a conventional wrench to tighten

the binding posts. Be sure the wires are not in contact with one another.

Interconnect cables

We recommend the use of high-quality balanced XLR audio interconnect cables with the

Momentum Stereo amplifier. If your preamp does not offer XLR output, use the high-quality

RCA-to-XLR adapters provided with the Momentum Stereo amplifier.

Connect the XLR cables to the inputs by pushing the cables onto the jacks. To release the

XLR cable, push on the small tab on the end of the jack then grasp the cable by the plug and

gently pull it out. Never grasp interconnect cables by the cable itself—you could damage the

cable.

AC cord

The Momentum Stereo amplifier is supplied with a high-quality Transparent Audio AC cord

tipped with a 15-amp IEC connector at the amplifier end and a three-conductor AC plug at

the other end. You may use a different power cord with the Momentum Stereo amplifier if

you wish, as long as it is tipped with a 15-amp IEC connector and a three-conductor AC plug.

After the speaker and interconnect cables are connected, push the IEC connector on the

power cord into the IEC jack on the Momentum Stereo amplifier.