Abt KODE900HBS Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Piekarnik Abt KODE900HBS. Abt KODE900HBS 20 stron. 27" (68.6 cm) and 30" (76.2 cm) electric single and double built-in oven flush installation kit

Drukuj stronę

Prepare Built-In Oven

NOTES:

Refer to the following "Installation Instructions" and

■

the "Installation Instructions" section of the Installation

Instructions provided with your built-in oven.

Refer and adhere to the "Electrical Requirements"

■

section, and complete the instructions in the "Make

Electrical Connection" section of the Installation

Instructions provided with your built-in oven.

1. Decide on the final location for the oven. Avoid drilling or

cutting into house wiring during installation.

WARNING

Excessive Weight Hazard

Use two or more people to move and install oven.

Failure to do so can result in back or other injury.

2. To avoid floor damage, set the oven onto cardboard prior

to installation. Do not use handle or any portion of the front

frame for lifting.

3. Remove the shipping materials and tape from the oven.

Remember to keep the corner posts and other materials that

may be needed for installation.

4. Remove the hardware package from inside the bag

containing literature.

5. Move oven and cardboard close to the oven's final location.

Remove Oven Door(s)

IMPORTANT: Use two hands to remove oven door(s).

1. Prior to removing the oven door, prepare a surface where

you will place it. This surface should be flat and covered with

a soft blanket, or use the corner posts from your packaging

material.

2. Open the oven door.

3. Locate the oven door hinge locks in both corners of the oven

door, and rotate the hinge locks toward the oven door to the

unlocked position. If the door hinge lock is not rotated fully

(see illustration B), the door will not remove properly.

A Oven door hinge lock

in locked position

INSTALLATION INSTRUCTIONS

B. Oven door hinge lock in

partially unlocked position

4. Partially close the door to engage the door latch locks. The

door will stop at this point.

5. Using two hands, grasp the edges of the oven door. Lift and

pull the oven door toward you, and remove. You may need to

gently shift door from side to side as you pull.

6. Set the oven door(s) aside on the prepared covered work

surface with the oven door resting on its handle.

7. To continue with the oven installation, go to the "Positioning

Oven Feet" section.