Elite Linnea Series Instrukcja montażu - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Wyposażenie wnętrz Elite Linnea Series. Elite Linnea Series 2 stron. Double bench with shared inset legv

Drukuj stronę

1. Half insert 8x Leg Frame Bolts 'G' into each Leg Frame 'B'

(16x in total) at position 'Z' leaving a 5mm gap for the Top Rail

to be inserted.

3. Place the Top Rails 'D' on top of the half inserted Leg Frame

Bolts 'G' and fully tighten.

5. Place Arms 'E' along the Top Rails 'D' over the pre-drilled

holes and fix together using the Top Rail Bolts 'J'.

2. If using a Double Bench with Shared Inset Leg, half insert

16x Shared Leg Frame Bolts 'H' into the Shared Inset Leg

Frame 'C' at position 'Z' leaving a 5mm gap for the Top Rail to

be inserted.

4. At this point place the Double Bench Cable Tray 'F' between

the middle 2 Top Rails 'D'.

This is not retro fittable and cannot be placed once the Desktop

is in place.

K&L

6. Place Desktop 'A' on a flat surface and attach 3x Sliders 'L'

to the scalloped end of the Desktop using 3x Slider Screws 'K'.

7. With assistance, turn Desktop 'A' and place it over the Arms

'D' so the 3x Sliders 'L' align with the apertures within the Arms

'E'.

9. If using a Double Bench Screen, attach Screen Bracket 'M'

to the topside of Leg Frame 'B' using Screen Bracket Bolt 'N'.

K&L

8. Push Desktop 'A' towards the centre of the assembled frame

and attach 3x Sliders 'L' near the front edge of Desktop using

3x Slider Screws 'K'.

The Linnea Double Bench is now complete.

10. Align Screen 'Q' to the Screen Brackets 'M' and connect

together so the Screen 'P' touches the Leg Frame 'C'.